Machining process parameters on green composite material

Abstract

In this work, the Abrasive water jet machining process on a natural fiber composite material has been discussed. the material as in nature fibere material. The natural fiber material has in a low weight material. In the material used in a light weight application. In the material mostly used in a automobile structural application. In the material not used in load condition application. In the material used in a unload condition material. The material was prepared by hand layup technique. The material was discussed about the machining character station of the process. For this process, the following parameters-standoff distance, abrasive flow rate, water pressure were determined. The output parameters considered are Material Remove rate and Surface roughness. in this condition the material removal rate will be increased and the surface roughness also increased. In the above condition was been solve the problem. The DOE was done by Mine tab software. Finally, the optimization result of the process has been conculded.