Determination of the Metallic Coating Properties Obtained by Thermal Spraying and Analysis of its Influence on the Heat Transfer Efficiency in the Thermoelectric Power Plant Boiler Tubes

Abstract

Mineral coal is a fuel that can be used by thermoelectric plants to generate electricity, however, the solid residues of its combustion, so-called ash, cause erosion and corrosion in the internal components of boilers that operate at high temperatures, causing failures in the system. This study proposes a metallic coating based on Fe-Cr-Si, obtained using the electric arc thermal spray technique as an alternative for protecting the most affected parts of boiler tubes by the ash impact. Optical microscopy (OM), scanning electron microscopy (SEM), semi-quantitative chemical analysis by Energy Dispersive Spectroscopy (EDS), X-ray diffraction (XRD), roughness measurements, pull-off adhesion tests were used. Thermal diffusivity measurements and mathematical modelling were elaborated to evaluate the thermal exchange efficiency impact of the coating in thermoelectric plant boiler tubes. The results showed that the chemical components of the sprayed wire were well incorporated into a coating with a hardness of 730.54 ± 164.28 HV, approximately three times greater than the hardness of boiler pipes and only 11% less than the hardness of ash. XRD identified the presence of crystalline phases in the coating and adhesion tests showed that the failures were cohesive without substrate exposure. The presence of the coating reduced heat exchange of approximately 0.64% / tube length. These results showed that the proposed coating, which has a lower cost compared to others, be a promising solution to avoid unscheduled shutdowns in thermoelectric boilers.