Correction to: Influence of the material manufacturing process on micromilling Ti6Al4V alloy (The International Journal of Advanced Manufacturing Technology, (2023), 129, 1-2, (23-35), 10.1007/s00170-023-12215-1)

Abstract

The original version of this article unfortunately contained a mistake on the Figures’ labels order from Fig. 7. The correct labels are: Fig. 7 Fx force results. Fig. 8 Fy force results. Fig. 9 Forces results for lower feed rate and higher tool diameter with emphasis on one edge of the tool not effectively cutting the material. Fig. 10 Tool run-out measurement for both tools. Fig. 11 Surface roughness results. Fig. 12 Main effect plot for Sa. Fig. 13 Burr formation results Fig. 13 was not included in the article, please find it below: (Figure presented.) In the text, from the fifth paragraph of Section 3.1, where it mentions “highlighted in Fig. 8”, please increase the citation number of the this and the subsequent figures by +1. The original article has been corrected.