Short-Term Influence of Water Ingress on Wear in Pitch Bearings of Wind Turbines

Abstract

The pitch bearings of wind turbines are slowly oscillating, grease-lubricated slewing bearings. They facilitate the pitching movements of blades which control aerodynamic loads. These bearings have diameters of several meters, their blade-side sealings can face the environment, bending moment loads can cause radial deformation of the bearing rings, and their highly variable operating temperatures can facilitate condensation of water inside them. All of this makes water ingress into the lubricant possible. There is limited public knowledge with regards to the maximum water content for safe operation in this application. This work presents the results of a series of scaled wind turbine time series tests with both ‘dry’ (no water contamination) and ‘wet’ (10 mass % demineralized water added) greases. A set of four commercially available greases were tested. The time series were scaled from wind turbine operation and represented a 13.7 h worst-case scenario of operation with small oscillation amplitudes and no longer lubrication runs in between. Three of the greases showed reduced friction and no or limited raceway damage in the wet condition, whereas one showed increased friction and raceway damages.