Radiation resistance of single-mode optical fibres with view to in-reactor applications

Abstract

Single-mode optical fibres (SMFs) are required for ITER in-vessel applications as transport fibres to deliver the signal at wavelength λ = 1.55 µm from/to optical fibre sensors. The paper describes the first comparison study of radiation resistance of six pure-silica-core SMFs of different manufacturers performed in the process of fission-reactor irradiation in the conditions corresponding to the whole ITER lifetime (fast-neutron fluence, flux, γ-dose and dose rate of up to 1.8·1020n/cm2, 1.08·1014n/(cm2·s), 2.32 GGy and 1.39 kGy/s, respectively, temperature of 170–190 °C and vacuum pumping). Polyimide- and acrylate-coated SMFs failed mechanically during the irradiation; therefore, only metal-coated fibres can be considered for the in-vessel applications. Induced optical loss in all three metal-coated SMFs (copper- and aluminum-coated ones) at the fast-neutron fluence of 1·1020n/cm2 was found to lie in the range ~1.5–4 dB/m, the lower value of this range allowing the employment of at least 10-m-long transport fibre lengths in the in-vessel applications, assuming the dynamic range of 30 dB. The temperature-dependent microbending optical loss in metal-coated SMFs is discussed, of which the contribution to the total induced loss may be comparable in value to the radiation-induced absorption of light. Neither radiation-induced luminescence, nor Cerenkov emission was detected in the SMFs in the near-infrared range.