Ultrashort Laser Pulses Applications

Abstract

Ultrashort laser pulses are considered to be pulses of electromagnetic radiation whose duration is shorter than the thermal vibration period of molecules, around tens of picoseconds (10 -12 s). Pulses with durations of a few picoseconds were already produced in the 1960’s (DiDomenico et al., 1966), shortly after the laser invention, using the mode-locking technique (Hargrove et al., 1964; Haus, 2000). In the next decade, refinements on this pulse generation scheme, and the use of bulky dye lasers with large emission bandwidths, shortened the pulses to the hundreds of femtoseconds (10 -15 s) timescale (Diels et al., 1978; Shank & Ippen, 1974). In the 1980’s, pulses with durations below 10 femtoseconds were generated from dye lasers (Fork et al., 1987; Knox et al., 1985), however the applications had to wait for the Ti:Sapphire Kerr- Lens mode-locked laser (Brabec et al., 1992; Spence et al., 1991) and the Chirped Pulse Amplification (CPA) technique (Strickland & Mourou, 1985) to really spread out. The large Kerr effect and broad emission bandwidth available in the Ti:Sapphire (Moulton, 1986), and the diode pumped solid state lasers (Keller, 1994; Keller, 2010; Scheps, 2002) that became available around this time, greatly simplified the setup needed to generate ultrashort pulses, and promptly replaced the dye lasers for this purpose. Finally, the invention of the CPA technique in 1985, allowed the generation of high intensity ultrashort pulses in all-solid state laser systems, and disseminated these laser systems due to its simplicity of operation when compared to the preceding systems, stability and relatively low cost. The CPA technique (Diels & Rudolph, 2006; Maine et al., 1988; Mourou et al., 1998) consists in generating ultrashort pulses with nanojoules of energy in a main oscillator laser, then temporally stretching these pulses by chirping its frequency (dispersion control) (Rullière, 1998) to decrease its power and intensity, allowing its amplification up to more than a million times without damaging the amplification chain components; after the amplification, the pulses are compressed to durations close to their original ones and directed to the applications. When the CPA technique became prominent, the pulses stretching and compression were mainly done with diffraction gratings (Fork et al., 1984; Martinez, 1987a; Martinez, 1987b; Treacy, 1969), although nowadays other techniques are disseminated, such as the use of Chirped Mirrors (Nisoli et al., 1997; Szipocs et al., 1994), fiber stretchers (Zhou et al., 2005) and prisms and grisms compressors (Chauhan et al., 2010). As the years went by, scientific and technological developments led to the dissemination of ultrashort pulses systems based in other mode-locking schemes such as SESAMs (Semiconductor Saturable Absorber Mirrors) (Keller, 2010) and gain media including Coherence and Ultrashort Pulse Laser Emission 664 chromium, ytterbium and neodymium doped crystals (Diels & Rudolph, 2006), neodymium doped glasses (Badziak et al., 1997), erbium doped fibers (Krauss et al., 2010), Optical Parametric CPAs (OPCPA) (Dubietis et al., 2006) and picosecond semiconductor lasers (Koda et al., 2010). The availability of systems with varying characteristics in many universities and research laboratories resulted in numerous ultrashort laser pulses applications in many areas. The great variety of ultrashort pulses laser systems available nowadays, both commercially and under development in laboratories around the world, is capable of generating pulses with durations in the range from a few femtoseconds to hundreds of femtoseconds, and picoseconds for the semiconductor lasers, wavelengths ranging from the ultraviolet spectrum (Reiter et al., 2010) up to 1.5 µm, energies extending from nanojoules to thousands of Joules (Stoeckl et al., 2006), terawatt peak powers in repetition rates up to few kilohertz (Bagnoud & Salin, 2000), and reaching tens of MHz at lower powers (Malinowski et al., 2004; Naumov et al., 2005). Powers over one petawatt (10 15 W) are generated in national laboratories (Chambaret et al., 2007; Gaul et al., 2010; Habara et al., 2010; Musgrave et al., 2007; Perry & Mourou, 1994; Tajima & Mourou, 2002), and intensities up to 10 22 W/cm 2 (Bahk et al., 2005) were obtained. Laser oscillators cannot generate pulses shorter than a few femtoseconds due to the wavelengths and bandwidths necessary for this, in the ultraviolet spectrum. Nevertheless, the use of High Harmonic Generation techniques allow the creation of pulses down to a few hundreds of attoseconds (10 -18 s) (Sansone et al., 2006). The applications of ultrashort laser pulses derive mainly from two characteristics of such pulses: firstly, their very short duration, which can be used to induce and measure ultrafast phenomena with temporal resolution of femtoseconds (and more recently with hundreds of attoseconds), besides minimizing heat transfer to the target. Secondly, the huge electric and magnetic fields associated to the pulses that can surpass the ones that bind electrons to atoms, resulting in large ionizations that lead to material modifications; the free electrons generated can also be accelerated by the electromagnetic field to high energies, even into the relativistic regime. The following sections will explore ultrashort laser pulses applications, roughly going from lower to higher energy (power, intensity) ones. Not all applications will be covered due to space limitations, and references will be given for those wanting a deeper understanding on the various subjects.