Utilization of Electronic Waste for Energy-saving Lamp Circuits

Abstract

Indonesia is one of the largest electronic consumer countries in the world. The negative impact unless the increase in the use of electrical energy, there is also an increase in electronic waste or e-waste. If electronic waste (e-waste) is not managed properly, it will cause its own problems, especially environmental health problems. One alternative to overcome these problems is the use of e-waste as a raw material for a series of Waste-Based Energy Saving Lamps, abbreviated as SLHE BBL. This study aims to develop SLHE BBL prototypes base on electric and electronics waste, and test the performance of SLHE BBL prototypes.The SLHE BBL method developed by research and development adapted from Borg & Gall with the following stages: First, needs analysis and product planning; Second: Initial product development, validation and initial product revision. Third: Product development, testing, product revision. Fourth: Finalization dan Dissemination. The research instrument consisted of an observation sheet, luxmeter, voltmeter, ammeter, multimeter, watt meter. The collected data was then analyzed quantitatively and descriptively.The results of the research are as follows: 1) waste that can be recycled into raw materials for SLHE BBL include: resistors, capacitors, LED lights on computer mice or electronic component indicators, used goods casings, adapters, diodes, cables, TV's control remote; 2) Electrical and mechanical design of SLHE BBL can be assembled into prototype of SLHE BBL; 3) The performance of the SLHE BBL prototype is that the lamp can be adjusted in colour and light intensity; the measured electrical parameters are within the range in accordance with the provisions of electrical standards such as Perasyaratan Umum Instalasi Lstrik (PUIL), International Electrical Commisionin (IEC), or National Electrical Code (NEC)