Determination of zinc-based additives in lubricating oils by flow-injection analysis with flame-AAS detection exploiting injection with a computer-controlled syringe

Abstract

A flow-injection system is proposed for the determination of metal-based additives in lubricating oils. The system, operating under computer control uses a motorised syringe for measuring and injecting the oil sample (200 μL) in a kerosene stream, where it is dispersed by means of a packed mixing reactor and carried to an atomic absorption spectrometer which is used as detector. Zinc was used as model analyte. Two different systems were evaluated, one for low concentrations (range 0-10 ppm) and the second capable of providing higher dilution rates for high concentrations (range 0.02%-0.2% w/w). The sampling frequency was about 30 samples/h. Calibration curves fitted a second-degree regression model (r2 = 0.996). Commercial samples with high and low zinc levels were analysed by the proposed method and the results were compared with those obtained with the standard ASTM method. The t test for mean values showed no significant differences at the 95% confidence level. Precision (RSD%) was better than 5% (2% typical) for the high concentrations system. The carryover between successive injections was found to be negligible. © 2005 Hindawi Publishing Corporation.