Evaluating reduced models of aggregated different doubly fed induction generator wind turbines for transient stabilities studies

Abstract

For the representation of wind farms in transient stability studies of electrical power systems, reduced models based on aggregating identical wind turbines are commonly used. In the case of a wind farm with different wind turbines coupled to the same grid connection point, it is usual to aggregate identical wind turbines operating in similar conditions into an equivalent one. However, in the existing literature, there are not any references to the aggregation of different wind turbines (same wind turbine technology but different rated power or components) into a single one. This paper presents a comparative study of four reduced models for aggregating different DFIG wind turbines, experiencing different incoming winds, into an equivalent model. The first of them is the classical clustering model, in which each equivalent model experiences an equivalent wind. The other reduced models have the same equivalent generation system but different equivalent mechanical systems. Thus, the second and third ones are compound models with a clustering aggregated mechanical system and individual simplified models, respectively, to approximate the individual mechanical power according to the incoming wind speeds. The fourth is a mixed model that uses an equivalent wind speed, which is applied to an equivalent mechanical system (equivalent rotor and drive train) in order to approximate the mechanical power of the aggregated wind turbines. The equivalent models are validated by means of comparison with the complete model of the wind farm when simulated under wind fluctuations and grid disturbances. Finally, recommendations with regard to the applicability of models are established.