Piping flexibility analysis of the primary cooling system of TRIGA 2000 bandung reactor due to earthquake

Abstract

Earthquakes in a nuclear installation can overload a piping system which is not flexible enough. These loads can be forces, moments and stresses working on the pipes or equipments. If the load is too large and exceed the allowable limits, the piping and equipment can be damaged and lead to overall system operation failure. The load received by piping systems can be reduced by making adequate piping flexibility, so all the loads can be transmitted homogenously throughout the pipe without load concentration at certain point. In this research the analysis of piping stress has been conducted to determine the size of loads that occured in the piping of primary cooling system of TRIGA 2000 Reactor, Bandung if an earthquake happened in the reactor site. The analysis was performed using Caesar II softwarebased finite element method. The ASME code B31.1 arranging the design of piping systems for power generating system (Power Piping Code) was used as reference analysis method. Modeling of piping systems was based on the cooling piping that has already been installed and the existing data reported in Safety Analysis Reports (SARs) of TRIGA 2000 reactor, Bandung. The quake considered in this analysis is the earthquake that occurred due to the Lembang fault, since it has the Peak Ground Acceleration (PGA) in the Bandung TRIGA 2000 reactor site. The analysis results showed that in the static condition for sustain and expansion loads, the stress fraction in all piping lines does not exceed the allowable limit. However, during operation moment, in dynamic condition, the primary cooling system is less flexible at sustain load, ekspansi load, and combination load and the stress fraction have reached 95,5%. Therefore a pipeline modification (rerouting) is needed to make pipe stress does not exceed the allowable stress. The pipeline modification was carried out by applied a gap of 3 mm in the X direction of the support at node 25 and eliminate the support at the node 30, also a gap of 3 mm was applied in X and Z directions of the support at the node 155. The axial force (FY) that occurred in the pump outlet nozzle (dia. 4 in.) of PriPump line have also exceeded the allowable limit that lead to the pump nozzle failure during an earthquake of Lembang fault. The modifications is necessary to be applied on the cooling system for PriPump line so the nozzle would not receive the force that exceed the allowable limits. The modification can be done by removing the support at node 105 and node 135 so the primary cooling system piping of Bandung TRIGA 2000 reactor would be safe to operate during an earthquake originated from Lembang fault.