A comparative study of e-beam deposited gate dielectrics on channelwidth-dependent performance and reliability of a-IGZO thin-film transistors

Abstract

A comparative study on the effects of e-beam deposited gate dielectrics for amorphous indium gallium zinc oxide (a-IGZO) thin-film transistors (TFTs) has been carried out using SiO2, Si3N4, and Ta2O5 dielectric materials. The channel width dependent device electrical performances were investigated using three different sizes of 500 μm, 1000 μm, and 1500 μm. The reliability characteristics were revealed by the threshold voltage variation and drain current variation under positive bias stress. The e-beam deposited high-k dielectric Ta2O5 exhibited the highest stability at the stress voltage of 3 V for 1000 s due to its high capacitance density at 34.1 nF/cm2. The threshold voltage variation along the channel width decreased from SiO2, then Si3N4, to Ta2O5, because of the increased insulating property and density of capacitance. The SiO2-based a-IGZO TFT achieved a high field effect mobility of 27.9 cm2/V˙s and on-off current ratio > 107 at the lower channel width of 500 μm. The gate leakage current also decreased with increasing the channel width/length ratio. In addition, the SiO2 gate dielectric-based a-IGZO TFT could be a faster device, whereas the Ta2O5 gate dielectric would be a good candidate for a higher reliability component with adequate surface treatment.