Design and evaluation of YBCO cable for the Albany HTS cable project

Abstract

The Albany Cable Project's aim is to develop a 350 meter long HTS cable system with a capacity of 800 A at 34.5 kV, located between two substations in the National Grid Power Company's grid. In-grid use of BSCCO HTS cable began on July 20, 2006, and successful long-term operation proceeded as planned. The cable system consists of two cables, one 320 meters long and the other 30 meters, a cable-to-cable splice in a vault, two terminations, and a cooling system. In Phase-II of the Albany project, this autumn, the 30-meter section will be replaced with YBCO cable. The test manufacturing and evaluation of YBCO cable has been carried out using SuperPower's YBCO wires in order to confirm the credibility of the cable design. No degradation of the critical current was found at any stage of manufacture. The fault-current test, involving a 1-meter sample carrying 23 kA at 38 cycles, was conducted under open-bath conditions. The temperature increases at the conductor and shield were comparable to those of the BSCCO core, and no Ic degradation was found after the fault-current test. After the design suitability was confirmed, a 30-meter YBCO cable was manufactured. The critical current of the conductor and the shield were approximately 2.6 kA and 2.4 kA, respectively, almost the same as the design values, considering the wire's Ic and the effect of the magnetic field. The AC loss of the sample cable was 0.34 W/m/phase at 800Arms and 60 Hz. Following favorable shipping test results, the YBCO cable was shipped to the United States, and arrived at the site in June 2007. © 2008 American Institute of Physics.