Synthesis of zno-cuo and zno-co3 o4 materials with three-dimensionally ordered macroporous structure and its h2 s removal performance at low-temperature

Abstract

H2 S is a common but hazardous impurity in syngas, biogas, or natural gas. For some advanced power generation technologies, such as integrated gasification combined cycle (IGCC), solid oxide fuel cells, H2 S content needs to be reduced to an acceptable level. In this work, a series of highly porous Zn-Cu and Zn-Co composites with three-dimensionally ordered macropores (3DOM) structure were synthesized via the colloidal crystal template method and used to remove H2 S at 150◦ C and one atm. Scanning electron microscopy (SEM), transmission electron microscopy (TEM), nitrogen adsorption studies, X-ray diffraction (XRD), and X-ray photoelectron spectroscopy (XPS) were carried out to analyze the fresh and spent adsorbents. The results show that all the adsorbents possess well-ordered macropores, a large surface area, and a highly dispersed active phase. The relative content of Zn and (Cu or Co) has a significant influence on the desulfurization performance of adsorbents. The addition of CuO significantly increases the sulfur capacity and 3DOM-Zn0.5 Cu0.5 shows the largest sulfur capacity of all the adsorbents, reaching up to 102.5 mg/g. The multiple adsorption/regeneration cycles of 3DOM-Zn0.5 Cu0.5 and 3DOM-Zn0.5 Co0.5 indicate that the as-prepared adsorbents are stable, and the sulfur capacity can still exceed 65% of the fresh adsorbents after six cycles.