Physical and biological implications of accelerated aging on stereolithographic additive-manufactured zirconia for dental implant abutment

Abstract

Purpose: This study aimed to comparatively investigate the effects of accelerated aging on the physical and biological features of zirconia manufactured by digital light processing (DLP) and conventional subtractive manufacturing (SM) with similar composition. Methods: Both the DLP-and SM-fabricated zirconia samples (7 mm × 7.5 mm × 1.5 mm) were grouped according to aging (134 °C, 0.2 MPa, 100% humidity) times, including 0 h, 5 h, and 10 h. Phase assemblage and surface topography of zirconia manufactured by different technologies were evaluated before and after aging. The biological effects of zirconia on human gingival fibroblast (HGF) cell events, including cell viability, proliferation, morphology and adhesion, were also evaluated by live/dead viability assay, cck-8 assay, scanning electron microscopy and confocal laser scanning microscopy respectively. Results: The DLP-fabricated zirconia showed a higher initial cubic phase content and rate of phase transformation than the SM-fabricated zirconia. Among the different aging time-based groups, the 5 h-aged group exhibited significantly lower sub-micron scale surface roughness compared with the other groups. Aging did not significantly alter cellular behavior in any zirconia type, except for minor changes in adhesive cell numbers recorded in an aging time/culturing time-dependent manner. In addition to small differences in cell alignment patterns and overall cell morphology, the two zirconia types presented comparable biological performance before and after aging. Conclusion: Although the microstructure and surface characteristics of DLP-fabricated zirconia can be affected by autoclave aging, this newly manufactured zirconia is likely to maintain desirable long-term biocompatibility as an implant abutment material.