Effect of polycondensation catalyst on fiber structure development in high-speed melt spinning of poly (ethylene terephthalate)

Abstract

We conducted a preliminary study on fiber structural development in the high-speed melt spinning of environmentally friendly polyethylene terephthalate (Ti-PET) synthesized with 25 ppm of titanium-based catalyst, which was compared with conventional PET (Sb-PET) synthesized with 260 ppm of antimony-based catalyst. Gel permeation chromatography of Ti-and Sb-PET resins of intrinsic viscosity 0.63 confirmed that both resins have similar molecular weights and distributions. However, differential scanning calorimetry revealed that the Ti-PET resin exhibited a lower melt-crystallization peak and isothermal melt-crystallization rate than the Sb-PET resin. High-speed melt spinning of the Ti-and Sb-PET was possible up to a spinning velocity of 6 km/min. Two-dimensional wide-angle X-ray diffraction analyses showed that the molecular orientation of the obtained as-spun Ti-and Sb-PET fibers increased with spinning velocity, and a highly oriented, crystalline structure by orientation-induced crystallization started to appear from 5 km/min. Notably, Ti-PET fibers showed a lower degree of crystalline structural development and lower tensile strength compared with Sb-PET fibers under the high-speed spinning conditions. Our results suggest that the catalyst in PET resins can act as nucleating agents in thermal-and orientation-induced crystallization, and that differences in catalyst content can influence PET fiber structure development under extreme conditions in high-speed melt spinning.