Comparing Percolation and Alignment of Cellulose Nanocrystals for the Reinforcement of Polyurethane Nanocomposites

Abstract

The reinforcement of polymer nanocomposites can be achieved through alignment or percolation of cellulose nanocrystals (CNCs). Here, we compare the efficacy of these reinforcement mechanisms in thermoplastic polyurethane (PU) elastomer nanocomposites containing thermally stable cotton CNCs. CNC alignment was achieved by melt spinning nanocomposite fibers, while a percolating CNC network was generated by solvent casting nanocomposite films with CNC contents up to 20 wt %. While in films both the CNCs and the PU matrix were entirely isotropic at all concentrations as confirmed by wide-angle X-ray scattering and birefringence analysis, the CNCs in the fibers exhibited a preferential orientation, which improved with increasing CNC concentration. Increasing the CNC concentration in the fibers reduces, however, the alignment of the PU chains, resulting in an entirely isotropic PU matrix at high CNC contents. The mechanical properties of films and fibers were evaluated using stress-strain measurements. Nanocomposite fibers with low CNC content exhibited superior stiffness, extensibility, and strength compared to the films, while the films displayed superior mechanical properties at high CNC concentrations. These findings are rationalized using common semiempirical models describing the reinforcing effects of CNC alignment in fibers (Halpin-Tsai) and CNC percolation in films (percolation model). The formation of a percolating CNC network leads to a stronger reinforcement than CNC alignment, as the reinforcing effect of the latter is limited by the comparably low aspect ratio of CNCs extracted from cotton. As a consequence, above the percolation threshold for cotton CNCs, isotropic nanocomposite PU films show a higher stiffness than aligned nanocomposite PU fibers.