PERFORMANCE OF ALKALINE SOLUTIONS ON GRADES OF GEOPOLYMER CONCRETE

Abstract

Geopolymer is a class of aluminosilicate binding materials synthesized by thermal activation of solid aluminosilicate base materials such as fly ash, metakaolin, GGBS etc., with an alkali metal hydroxide and silicate solution. The geopolymer was activated with sodium hydroxide, sodium silicate and heat. This paper presents the experimental investigation done on the variation of alkaline solution on mechanical properties of geopolymer concrete. The grades chosen for the investigation were M-30, M-40, M-50 and M-60, the mixes were designed for 8 molarity. The alkaline solution used for present study was the combination of sodium silicate and sodium hydroxide solution with the varying ratio of 2, 2.50, 3 and 3.50. The test specimens were 150x150x150 mm cubes and 100x200 mm cylinders heat-cured at 60°C in an oven. The results revealed that the workable flow of geopolymer concrete was in the range of 85 to 145 and was dependent on the ratio by mass of sodium silicate and sodium hydroxide solution. The freshly prepared geopolymer mixes were cohesive and their workability increased with the increase in the ratio of alkaline solution. The strength of geopolymer concrete can be improved by decreasing the water/binding and aggregate/binding ratios. The curing period improves the polymerization process resulting in higher compressive strength. The geopolymer concrete do not have any Portland cement, they can be considered as less energy interactive. It utilizes the industrial wastes such as fly ash for producing the binding system in concrete. The obtained compressive strength and split tensile strength were in the range of 20.64-60 N/mm 2 and 3-4.9 N/mm 2. The optimum dosage for alkaline solution can be considered as 2.5, because for this ratio the GPC specimens of any grade produced maximum strength in compression and tension.