Siltstone Geochemical Compositions: Applications for Event Size and Correlation

Abstract

Thinly laminated siltstone and sandy siltstone are major components of the Upper Permian Brushy Canyon Formation, west Texas and south New Mexico. These rocks have been variously interpreted as the deposits of low-density turbidity currents or as windblown sediment deposited over water. Nevertheless, all models agreed that this lithology was deposited without subsequent reworking by bottom currents or burrowing organisms. These siltstones, thus, are ideal test units for quantitatively estimating hydraulic properties of the flows that formed them. In particular, the Zr/Ti ratio was tested as a geochemical proxy for flow size and transport distance. In situ geochemical abundance and grain size of particles with contrasting susceptibility to erosion—Zr- and Ti-rich particles—were mapped and measured by X-ray fluorescence analytical microscopy, µXRF. Lamination thickness was measured from Fe fluorescence intensity, which increased sharply at the top of each layer. Within the same sample, zircon grains were systematically finer than rutilated quartz grains. Zr/Ti fluorescence ratio positively correlated with lamination thickness, not particle sizes. In other words, Zr/Ti fluorescence ratio fluctuations resulted from variations in mineral abundance. Therefore, variations of Zr/Ti fluorescence ratio in these siltstones are likely caused by fluctuations in the intensity of erosional events rather than transport distance. High Zr/Ti ratios and thick laminations reflect periods of enhanced erosion. The average wind velocity during typical events was estimated to be at least 150 km∙hr−1, or the equivalent of a Category 1 hurricane. The method used here could be applied to both outcrop and subsurface strata correlation.