Mechanical and morphostructural characteristics of composite materials performed by recycling mixed waste of plastic and paper

Abstract

In order to evaluate the possibility of reuse of some mixed waste from plastic and paper, composite samples of both HDPE and PP basis were made with different filler contents of crushed postage envelope waste. From the morphostructural characterization (SEM images) of the samples obtained it was observed that the HDPE and PP samples had had a homogeneous single-phase structure in contrast to the composite samples with filler from mixed plastic and paper waste. The latter, have a biphasic heterogeneous structure in which the cellulose particles are uniformly distributed. Determinations performed through the dielectric spectroscopy technique indicated that the cellulose content of the composite samples leads to a systematic increase of the dielectric losses (up to about 40% for the HDPE samples, respectively about 30% for the samples with PP), the increases being in direct correlation with the cellulose content of the composite. Mechanical determinations have shown that the average values of tensile strength recorded on the achieved samples, systematically decrease at the increase in the chips content of the samples - decreases up to 10% at an addition up to 15% chips from the waste are explained by the substantially lower mechanical strength of waste paper than that of the HDPE, respective PP.