Fabrication and mechanical response of commingled GF/PET composites

Abstract

The mechanical properties and the response to mechanical load of continuous glass fiber reinforced polyethylene terephthalate (GF/PET) laminates have been characterized. The laminates were manufactured by compression molding stacks of novel woven and warp knitted fabrics produced from commingled yarns. The laminate quality was examined by means of optical and scanning electron microscopy. Few voids were found and the laminate quality was good. Resin pockets occurred in the woven laminates, originating from the architecture of the woven fabric. The strength of the fiber/matrix interface was poor. Some problems were encountered while manufacturing the laminates. These led to fiber misalignment and consequently resulted in tensile mechanical properties that were slightly lower than expected. Flexural failures all initiated as a result of compression, and it is possible that the compression strength of the matrix material, rather than its tensile strength, might limit the ultimate mechanical performance of the composites. Flexural failures for both materials were very gradual. The warp knitted laminates were stronger and suffer than the woven laminates. The impact behavior was also investigated; the woven laminates exhibited superior damage tolerance compared with the warp knitted laminates.