Defect evolution during annealing of deformed FeSi alloys studied by positron annihilation spectroscopy

Abstract

High silicon steel is widely used in electrical appliances. Alloying iron with silicon improves its magnetic performance. A silicon content up to 6.5 wt. gives excellent magnetic properties such as high saturation magnetization, near zero magnetostriction and low iron loss in high frequencies. Their workability is greatly reduced by the appearance of ordered structures, namely B2 and D03, as soon as the Si content becomes higher than 3.5 wt. %. This limits the mass production by conventional rolling to this maximum percentage of Si. In this work a series of FeSi (7.5 wt.% Si) samples with different degrees of deformation are investigated with positron annihilation spectroscopy and optical microscopy (OM). The influence of annealing on the concentration of defects of different deformed FeSi alloys has been investigated by positron annihilation lifetime spectroscopy and Doppler broadening of the annihilation radiation. OM is used to investigate the microstructure of deformed samples before and after annealing. The values of the S parameter present a decrease for all studied FeSi alloys with the increase of the annealing temperature, being attributed to a decrease of the concentration of defects. A sudden increase of the S-parameter value at 600 C was observed for all samples, which could be related to the change of the ordering of the FeSi alloys at that temperature. At 700 C, the values of the S parameter decreased drastically and starting from 900 C, they became constant. The microstructures of the alloys, investigated by OM, show that recrystallization is completed at 900 C and the samples are mainly free of defects, which is in agreement with the positron annihilation lifetime data. © 2011 American Institute of Physics.