Optimum planting configuration for high population plasticulture grown cabbage

Abstract

Florida is a major fresh-market cabbage (Brassica oleracea L. var. capitata) producing state in the United States. The current cabbage production systemrelies on bare ground and subirrigation that requires a large volume of water to irrigate the crop. The bare ground system facilitates a maximum of 48,438 plant/ha, while there is a potential to increase plant population per area using plasticulture and drip irrigation. The objectives of this study were to determine the optimum cabbage plant population and plant arrangement that maximizesmarketable yield per area for a high cabbage population plasticulture system. Cabbage was grown on 1.2-m-wide raised beds with black plastic mulch and drip irrigation. Plants were grown in either three or four rows with in-row plant spacings ranging from 15 to 35 cm and plant populations ranging from 41,518 to 129,167 plants/ha. Cabbage marketable yield increased as in-row spacing increased. Yields ranged from 19.7 to 69.7 Mg·ha−1. Marketable yield was not different between 3 and 4 rows for in-row spacings above 25 cm. The 15 and 20 cm in-row spacing produced significantly lower yields in the 4-row configuration as compared with the 3-row configuration in Fall and Winter 2011. Wider in-row spacings produced a greater percentage of heads of marketable size while reducing the percentage of small heads when compared with narrower in-row spacings. Mean head weight increased as in-row spacing increased and a 3- or 4-row configuration with an in-row spacing between 25 and 30 cm had consistently high yields in all three seasons compared with narrower in-row plant spacings. These results indicated that with a high population plasticulture system variable plant populations could be selected. In-row plant spacings between 30 and 35 cm may be beneficial for early plantings while a 25-cm spacing could be more productive for later plantings, especially when weather conditions are favorable.