A Water-Soluble Core for Manufacturing Hollow Injection-Molded Products

Abstract

To manufacture a complicated hollow product without any assembly process, for example, the plastic intake manifold, is difficult by the traditional injection molding method. The fusible-core technique, which uses a low-melting-point alloy as a sacrificial core, was developed to solve this problem; however, the limited selection of resin type and the huge capital investment have caused this technique to spread slowly. In this work, a novel method is established that can produce similar products without the limitation of resin type, as well as a lower-energy-consumption process. The concept of the enveloped core defined by a water-soluble core assembled with a shell is proposed herein; it provides both rigidity and toughness to resist the pressure during the injection molding process. The shape of the enveloped core equals the internal contour of the designated product. An insert molding process was introduced to cover the enveloped core with a skin layer. Cut out the end of the enveloped core and immerse it into a water bath. When the water-soluble core inside the shell is dissolved, the product with a special internal contour is accomplished. A tee-joint is presented to demonstrate how the proposed method can be utilized. The optimal ingredient of the core and processing parameters are determined by the Taguchi method. The result shows that the proposed product is molded successfully when the compressive strength of the core is larger than 2 MPa. In addition, the eccentricity measurement of internal contour of the optimal sample exhibits a 56% improvement, and the required time for the core removal is less than 154 s.