CO2-brine injectivity tests in high co2 content carbonate field, sarawak basin, offshore east Malaysia

Abstract

We conducted relatively long duration core-flooding tests on three representative core samples under reservoir conditions to quantify the potential impact of flow rates on fines production/permeability change. Supercritical CO2 was injected cyclically with incremental increases in flow rate (2? 14 ml/min) with live brine until a total of 7 cycles were completed. To avoid unwanted fluid-rock reaction when live brine was injected into the sample, and to mimic the in-situ geochemical conditions of the reservoir, a packed column was installed on the inflow accumulator line to pre-equilibrate the fluid before entering the core sample. The change in the gas porosity and permeability of the tested plug samples due to different mechanisms (dissolution and/or precipitation) that may occur during scCO2/live brine injection was investigated. Nuclear magnetic resonance (NMR) T2 determination, X-ray CT scans and chemical analyses of the produced brine were also conducted. Results of pre-and post-Test analyses (poroperm, NMR, X-ray CT) showed no clear evidence of formation damage even after long testing cycles and only minor or no dissolution (after large injected pore volumes (PVs) ~ 200). The critical flow rates (if there is one) were higher than the maximum rates applied. Chemical analyses of the core effluent showed that the rock samples for which a pre-column was installed do not experience carbonate dissolution.