Surface laser alloying of 17-4PH stainless steel steam turbine blades

Abstract

As a known high-quality precipitation hardening stainless steel with high strength, high antifatigue, excellent corrosion resistance and good weldability, 17-4PH has been widely used to produce steam turbine blades. However, under the impact of high-speed steam and water droplets, the blades are prone to cavitation, which could lead to lower efficiency, shorter life time, and even accidents. In this article, the 17-4PH blade's surface was alloyed using a high power CO2 laser. The microstructure and microhardness of hardened 17-4PH were tested by scanning electronic microscope (SEM), X-ray diffraction (XRD), energy disperse spectroscopy (EDS) and a microhardness tester. After laser alloying, the surface layer was denser and the grain refined, while the microhardness of the surface (average 610HV0.2) was about one times higher than that of the substrate material (330HV0.2). The friction coefficient of the laser-alloyed 17-4PH layer was much lower than that of the substrate. © 2007 Elsevier Ltd. All rights reserved.