Microstructural Changes in Vanilla planifolia Beans after Using High-Hydrostatic-Pressure Treatment in the Curing Process

Abstract

During vanilla bean curing, the cell arrangement derived from the killing technique applied to start bean ripening is essential to obtain the characteristic aroma and flavor of vanilla. Hence, killing is an important step to release the enzymes and compounds required for vanillin production. In this work, high hydrostatic pressure (HHP) at 100–400 MPa for 5 min, using water at 7 °C as the pressure-transmitting medium, was applied as the killing method, and its effect on the microstructural changes in vanilla beans during different curing cycles (C0–C20) was evaluated and compared with that observed after scalding by using water at 100 °C for 8 s. Microstructural changes in the cross-sectioned beans were analyzed using a stereomicroscope (SM), confocal laser scanning microscopy (CLSM), and environmental scanning electron microscopy (ESEM). The vanilla beans were cross-sectioned and three main sectors were analyzed: the total, annular, and core. The morphometric descriptors, namely, area, Feret’s diameter, and circularity, were quantified via digital image analysis (DIA), from which a shrinkage ratio was calculated. The results show that the total area in the beans presented a maximum decrease in the C16 of curing. The core area was most affected by the HHP treatment, mainly at 400 MPa, rather than scalding. CSLM observations revealed the autofluorescence of the compounds inside the beans. In conclusion, the use of microscopy techniques and DIA allowed us to determine the microstructural changes in the HHP-treated pods, which were found to be more numerous than those found in the scalded beans.